Oregon Coastal Center and Solar Hot Water System

A modern solar water heater seems too costly and complex, with thoughts of: pumps, collectors, a maze of plumbing, numerous temperature probes, and a differential thermostat. All requiring electricity to run properly.

The Oregon Coast Center wants to build an effective solar water heater that doesn't require a single watt of electricity to get its liquid from one place to another. This is our design

A water-heating setup circulates through the courtesy of an everyday physical phenomenon: Heated fluids rises. This is because their lower density in comparison to the same substances when they're cooler. Hence, circulation occurs when cold water in the system falls from the storage tank which sits at least two feet above the top of the collectors. At the same time, water inside the solar panels are heated and tends to rise and flow back toward the storage tank. The imbalance in densities and therefore in gravitational attraction forms a complete convective loop. Because the "pump" of the thermosiphon setup is the heat of the sun itself, the intensity of that radiation regulates the volume of flow through the pipes. In fact, when the sun stops shining on the collectors, the system is effectively shut off.

However, though the concept of thermosiphoning is elegantly simple, there are a few basic rules to follow when designing such a hot water system.

First, the convective loop will work properly only if the bottom of the storage tank is at least a foot and a half above the top of the collector. This head is necessary to build pressure in the system and to help prevent back-flow at night.

Furthermore, the connections to the storage tank need to be properly located in a convective-loop solar hot water setup. The cold line to the collectors should exit at the bottom of the tank, and the hot return must enter near the top. The cold line, however, shouldn't be placed in such a way that its effective head will be less than that of the hot water return.

Because thermosiphon systems rely on relatively weak convective forces to provide their circulation, they need to be built with generously sized tubing to reduce pipe friction. Depending on the distance between the collector and the storage tank, then, the pipes should be at least 3/4" in diameter, and 1 " would be preferable. All pipes must be thoroughly and equally insulated. In addition, the feed and return lines should be pitched evenly from the collector to the tank without any significant dips that could catch air bubbles.